Class Level 3 (In-Person)

 This is a charged class

$1,500.00 Per seat. Must provide P.O.# before.

 This class will go over fully removing and reinstalling a spindle on a actual DVF 5000. Fully dissemble and pull the spindle cartridge from the headstock. Go over the concept of measuring and adjusting the endcap gap, BZi sensor, LVDT sensor, pusher gap, and rotary union. Also talk about the drawbar, how to check clamp force, drawbar stroke, tool kick-out, and retention stroke.  Spindle Assembly. Practical: How to properly break in a spindle, and how to use a spindle balancer to balance the spindle (while it is in the machine).

This is a Machining Center Class (MC)

This is a Full Week class, in person @ our CTC

Day 1 = 1P.M. to 4 P.M.

Day 2 = 9 A.M. to 4 P.M.

Day 3 = 9 A.M. to 4 P.M.

Day 4 = 9 A.M. to 4 P.M.

Day 5 = 9 A.M. to 12 P.M.

Class Level 3 (In-Person)

This is a charged class

 $1,000.00 Per seat. Must provide P.O.# before.

 Disassemble the index table, go over the Curvic coupling structure and how it differs from the clamping plate. Adjust the backlash in the gears and go over the hydraulic manifold. Disassemble the full rotary table. Go over the concept of the hydraulic clamp on how to measure/set the proper gap for operation. Go over checking the backlash on the system and how to reinstall all the components.

This is a Machining Center Class (MC)

This is a 2 day class, in person @ our CTC

Day 1 = 9 A.M. to 4 P.M.

Day 2 = 9 A.M. to TBD